Owner manual

0
10
20
30
40
3
Boom & Tail Rotor
Take special care to get the boom long
enough into the tail assembly for correct tail
length before you tight this bolt.
Pos Description Qty
1 M3x75 Socket Head Bolt 4
2 3mm Washer 11
3M3NylonNut 8
4 M3X16 Socket Head Bolt 2
5 M3X25 Socket Head Bolt 3
6 M3X10 Socket Head Bolt 3
7 Boom Support Collar 2
8 M2.5X6 Socket Head Bolt 2
3
4
3
2
Be careful not to over tighten the
bolts when attaching the tail rotor
blades. The tail blades should be
able to move with a slight amount
of resistance within the tail blade
holders.
To pull the belt through the tail boom, slide a cord through
the boom and fix the belt very carefully at the cord. You can
also use a strand and bend a hook at one of the ends.
Crimping the belt damages the
tensile cords and will result in
premature failure!
Slide the tail case completely onto the boom, align it to
the Compass writing and fix it with the clamp on the rear
side. The two locking bolts ( 8 )must be screwed
completely into the case to pierce the boom. After this
step, the angle of the writing can not be adjusted any
more!
6
Tip: Do not tighten the bolt of the belt
idler pulley yet, it will be adjusted later.
Use medium Threadlock on all
screws going into metal parts
Tip: You can use a very small drop of thin
CA glue to secure the pin in the tail pulley.
2
6
8