Manual

Main Grip
Apply Grease Here
Larger ID
(IN)
Smaller ID
(OUT)
Thrust Bearing Direction
Main grips are factory preassembled; in case of reassembling
make absolutely sure you use the correct “ID” ring at the correct
position. Place the large ID Towards the Main Shaft and the
small I.D. Towards the Blades during assembly.
Team Tips
General:
Step 3
Step 4
Step 5
The Ball Links on theAtom need to be resized.These Ball Links will NOTbreak in over time. they
will stay tight and will cause unwanted interactions.
It is very important to resize the Ball Links for smooth travel, especially on the tail; because issues
like tail wag, sluggish tail, or inconsistent Piro-rate will occur.
It is vital not to over tighten the Main Gear Bolt, or it can cause theAutorotation Gear to slightly
warp.This can cause a prematureBelt failure, or reduce the lifetime of the Belt.
:
To improve '3D' Tail Rotor authority we suggest doing the “Tail Blade Grip Flip”.The result is
a increased stability in 3D flying.
:
:
LeaveAbout 0.1mm space between the Flybar Collar and the Flybar Holder, this avoids the
Flybar to snap when flying.