User`s guide

3–Configuring Fibre Channel
Selective LUNs
FC0054609-00 B 3-13
3. On the HBA Parameters menu, select Configure HBA Parameters to
open the Configure Parameters menu with options to configure connection
options, data rate, frame size, hard loop ID, loop reset delay, BIOS, Fibre
Channel tape support, operation mode, interrupt delay timer, login retry
count, port down retry count, LIP full login, link down timeout, target reset,
LUNS per target, and receive out-of-order frames.
Refer to the section about the Fibre Channel interactive commands in the
QConvergeConsole CLI User’s Guide for information.
Configuring Fibre Channel Driver Parameters with the
Noninteractive QCC CLI
Type the following command to configure the driver settings:
# qaucli -pr fc -fs (<hba instance> | <hba wwpn>) {(<param name> | <param
alias>) <param value>}
Where:
hba instance = Adapter instance number of an adapter port (use the -g
command to find)
hba wwpn = Worldwide port name of the adapter
param name = Name of the parameter
param alias = Alias of the parameter
param value = New value of the parameter
Refer to the section about the Fibre Channel noninteractive commands in the
QConvergeConsole CLI User’s Guide for information.
Configuring Fibre Channel Driver Parameters with the QLogic
QConvergeConsole Plug-in for VMware vCenter Server
See the QLogic QConvergeConsole Plug-in for VMware vCenter Server User’s
Guide for details on how to configure the Fibre Channel driver parameters.
Selective LUNs
The QCC GUI cannot be used for configuring selective LUNs.
To configure selective LUNs with the interactive QCC CLI, refer to the section
about the Fibre Channel interactive commands in the QConvergeConsole CLI
User’s Guide.
To configure selective LUNs with the noninteractive QCC CLI, refer to the section
about the Fibre Channel noninteractive commands in the QConvergeConsole CLI
User’s Guide.