User`s guide

3–Configuring Fibre Channel
Boot Devices Configuration
3-6 FC0054609-00 B
target port id = Port ID of the target
target id = ID to which the target is bound
Refer to the section about Fibre Channel noninteractive commands in the
QConvergeConsole CLI User’s Guide for information.
Boot Devices Configuration
Configuring Boot Devices with the QCC GUI
Refer to the topics about HBA parameters, viewing or modifying port parameters,
and boot device selection in the QConvergeConsole Help System for information.
Configuring Boot Devices with the Interactive QCC CLI
On the Fibre Channel Adapter Configuration menu, select Boot Devices
Configuration to open the Boot Device Settings menu with options to view and
configure boot devices.
Refer to the section about the Fibre Channel interactive commands in the
QConvergeConsole CLI User’s Guide for information.
Configuring Boot Devices with the Noninteractive QCC CLI
Type the following command to set a specific target as the boot device for a
specific adapter:
# qaucli -pr fc -e (<hba instance> | <hba wwpn>) <target wwnn> <target wwpn>
<target id> <lun id>
Where:
hba instance = Adapter number (use the -g command to find)
hba wwpn = Worldwide port name of the adapter
target wwnn = Worldwide node name of the target
target wwpn = Worldwide port name of the target
target id = ID to which the target is bound
lun id = ID of the LUN
Refer to the “Fibre Channel Noninteractive Commands” section of the
QConvergeConsole CLI User’s Guide for more information.
Configuring Boot Devices with the BIOS
Refer to Fibre Channel Adapter Function Configuration Utility for information.