User`s guide

3–Configuring Fibre Channel
Target Persistent Binding
FC0054609-00 B 3-5
5. Click the Bind check box if you want to configure a specific port and bind it
to the target ID that you have selected from the Target ID list. If you do not
want to configure the port, clear the check box. If you clear the check box,
the corresponding port is unconfigured.
6. Click Save to save the configuration changes.
The Security Check dialog box may appear.
7. In the Enter Password box, type the password and click OK.
The system overwrites any previously saved configuration for the current
adapter and displays a message box.
8. Click OK to close the message box.
Refer to the topic about binding target devices in the QConvergeConsole Help
System for more information.
Configuring Persistent Binding with the Interactive QCC CLI
To bind a target using the interactive QCC CLI:
1. On the Fibre Channel Adapter Configuration menu, select Target
Persistent Bindings.
2. On the port menu, select a port and then select Bind Target(s) to bind a
target to a port.
3. Select a target and specify a target ID to open the Target Persistent Binding
– FC Port Configuration menu with options to select more targets, save
changes, or cancel the binding operation.
Refer to the section about Fibre Channel interactive commands in the
QConvergeConsole CLI User’s Guide for more information.
Configuring Persistent Binding with the Noninteractive QCC
CLI
Type the following command to bind a selected target to a specific adapter:
# qaucli -pr fc -p (<hba instance> | <hba wwpn>) (<target wwnn> <target wwpn>
<target port id> <target id>)
Where:
hba instance = Adapter number (use the -g command to find)
hba wwnn = Worldwide node name of the adapter
hba wwpn = Worldwide port name of the adapter
target wwnn = Worldwide node name of the target
target wwpn = Worldwide port name of the target