User`s guide

3–Configuring Fibre Channel
Fibre Channel Adapter Parameters
3-4 FC0054609-00 B
Fibre Channel Adapter Parameters
Setting Fibre Channel Adapter Parameters with the QCC GUI
Refer to the topic about managing Fibre Channel and FCoE adapter ports in the
QConvergeConsole Help System for information.
Setting Fibre Channel Adapter Parameters with the Interactive
QCC CLI
To set Fibre Channel Adapter parameters with the interactive QCC CLI:
1. On the Fibre Channel Adapter Configuration menu, select HBA
Parameters.
2. On the port menu, select a port to open the HBA Parameters menu.
3. On the HBA Parameters menu, select the Configure HBA Parameters
option to open the Configure Parameters menu.
Refer to the section about the Fibre Channel interactive commands in the
QConvergeConsole CLI User’s Guide for more information.
Setting Fibre Channel Adapter Parameters with the
Noninteractive QCC CLI
Refer to the section about Fibre Channel noninteractive commands in the
QConvergeConsole CLI User’s Guide for information.
Target Persistent Binding
Configuring Persistent Binding with the QCC GUI
To bind target devices attached to an adapter port using the QCC GUI:
1. In the system tree, expand a Fibre Channel node.
2. For a 2600 Series Adapter, select the physical port number in the system
tree.
3. Click the Targets tab and then click the Target Persistent Binding subtab.
4. Click the Bind All check box to bind all the devices listed to adapter ports.
NOTE
Target persistent binding is supported for only Windows and Solaris.