User`s guide

2–Installing Software and Initial Setup
Multi-boot Image for Fibre Channel Adapter Function Configuration Utility
2-12 FC0054609-00 B
set-port-down-count 1h–FFh This command determines the number of retries
for the Start, Read, and Write SCSI commands.
The default value is 30h.
set-max-frame-size 1, 2, 3 This command sets the Maximum Frame
Length field in the IFCB:
 1—512
 2—1024
 3—2048. This setting is the default.
set-boot-wait-time 8–65535 This command adjusts the time to wait in sec-
onds for the boot device to become online. The
default value is DISABLED, which sets it to
8 seconds. The maximum value is 65,535 sec-
onds (18 hours, 6 minutes). The minimum value
is 8 seconds, same as when disabled. Because
this wait time can be very long, the boot process
cap be aborted at any time by pressing the
ESCAPE key.
restore-default-settings NA This command restores the default values of all
NVRAM parameters used by the FCode, except
the fc-mode (FCode operation mode) and the
boot-wait-time.
set-personality FC, CNA
This command sets or clears bits in the fea-
ture configuration section of the Flash
memory, which controls the card personal-
ity. A power cycle is required for a change
to take effect.
Dual personality is currently disabled and
will be enabled in a future firmware
upgrade.
 FC—Fibre Channel only
 CNA—Converged Network Adapter
Table 2-4. NVRAM Parameters (Oracle SPARC) (Continued)
Command Values Description