User`s guide

2–Installing Software and Initial Setup
Multi-boot Image for Fibre Channel Adapter Function Configuration Utility
FC0054609-00 B 2-11
Setting and Viewing NVRAM Parameters
Table 2-4 describes the NRAM parameters that you can set and view.
Table 2-4. NVRAM Parameters (Oracle SPARC)
Command Values Description
show-commands N/A This command lists all NVRAM and diagnostic
commands.
show-settings N/A This command shows the current value of all of
the NVRAM parameters, as well as the version,
serial number, and adapter worldwide name.
set-connection-mode 0, 1, 2 This command allows you to change or view the
current host adapter Fibre Channel connection
mode:
 0—Loop only
 1—Point-to-point only
 2—Loop preferred; otherwise, point-to-point
set-data-rate 2, 3, 4, 5 This command allows you to change or view the
current host adapter Fibre Channel connection
mode:
 2—Auto-negotiated
 3—4Gbps
 4—8Gbps
 5—16Gbps
set-fc-mode qla, qlc This command allows you to set and view the
FCode operation mode:
 qla—The qla mode requires a driver named
QLA2300 or QLAxxxx.
 qlc—The qlc mode requires a driver named
QLCxxxx.
set-login-count 1h–FFh This command sets the Login Retry Count field
in the initialize firmware control block (IFCB).
This field specifies the number of login retries
attempted by the firmware. The default value
is 8h.
set-link-timeout 2h–FFh This command determines the number of sec-
onds to wait for the link to come up. The default
value is 30 seconds (1Eh).