User`s guide

2–Installing Software and Initial Setup
Multi-boot Image for Fibre Channel Adapter Function Configuration Utility
FC0054609-00 B 2-9
Scan Fibre Devices
This option scans the Fibre Channel loop and lists all the connected devices by
loop ID. It lists information about each device; for example, vendor name, product
name, and revision. This information helps when configuring your 2600 Series
Adapter and attached devices.
Fibre Disk Utility
This option scans the Fibre Channel loop and lists all the connected devices by
loop ID. You can select a Fibre Channel hard disk and do one of the following
tasks:
 Perform a low-level format
 Verify the disk media
 Verify the disk data (Some targets do not support this feature.)
 Select a disk device
Enable
Interrupt
Yes/No No This setting enables or disables the interrupt:
 Yes—This setting enables the BIOS to use the
interrupt request (IRQ) assigned to the 2600
Series Adapter.
 No—The BIOS polls for the 2600 Series
Adapter's RISC controller mailbox command
completion status.
EV Con-
troller
Order
Enabled/
Disabled
Dis-
abled
This setting enables BIOS compatibility with older
HP
®
(G3) systems such as the ML370G3,
DL360G3, and DL380G3. In the default setting, the
Host Bus Adapter BIOS loads in any CMOS loca-
tion, allowing the system to boot off a Fibre Channel
drive even after other devices, such as a CD-ROM.
When enabled, the QLogic BIOS loads only if the
2600 Series Adapter is selected as the first control-
ler in the system BIOS\boot controller order.
CAUTION
Performing a low-level format destroys all data on the disk.
Table 2-3. Advanced Adapter Settings (Continued)
Setting Values Default Description