User`s guide

2–Installing Software and Initial Setup

Multi-boot Image for Fibre Channel Adapter Function Configuration Utility

2-6 FC0054609-00 B

This option allows you to specify up to four WWPNs/LUNs as boot devices.

To enable the Selectable Boot option and insert devices into the boot device

locations:

1. On the Configuration Settings menu, select Host Adapter Settings.

2. Enable the Host Bus Adapter BIOS and then press the ESC key to return

to the Configuration Settings menu.

3. On the Configuration Settings menu, select Selectable Boot Settings.

4. Press the ENTER key to enable or disable (toggle) the Selectable Boot

option. Use the DOWN ARROW key to move to the Primary location of the

Selectable Boot List menu.

5. Press the ENTER key to see a list of accessible devices (in the Select Fibre

Channel Device menu).

6. Select a drive (using the UP ARROW and DOWN ARROW keys or the

PAGE UP and PAGE DOWN keys to scroll to the device you want to put into

your Selectable Boot menu list) and then press the ENTER key to select the

requested device and load it into the Selectable Boot menu list.

7. To specify an alternate boot device on the 2600 Series Adapter, use the

arrow keys to move to the next available alternate entry, press the ENTER

key, select the disk drive you want, and press the ENTER key. You can

specify up to three alternate boot devices in this way.

Yes Specified The BIOS scans through the specified boot worldwide port

name (WWPN)/LUN list until it finds a disk drive. This drive

is configured as the boot device.

Table 2-2. Selectable Boot Settings (Continued)

Enable

Selectable

Boot

WWPN/

LUN

Device Boot