User`s guide

2–Installing Software and Initial Setup
Multi-boot Image for Fibre Channel Adapter Function Configuration Utility
2-4 FC0054609-00 B
The Fast!UTIL Options menu provides the following options:
 Configuration Settings
 Scan Fibre Devices
 Fibre Disk Utility
 Loopback Data Test
 Select Adapter
 Personality
 Exit Fast!UTIL
Configuration Settings
The following topics show and describe the 2600 Series Adapters configuration
settings:
 Adapter Settings
 Selectable Boot Settings
 Restore Default Settings
 Raw NVRAM Data
 Advanced Adapter Settings
Adapter Settings
Table 2-1 describes the adapter settings.
Table 2-1. Adapter Settings
Setting Values Default Description
Host Bus
Adapter
BIOS
Enabled/
Disabled
Disabled Disabling this setting disables the ROM BIOS
on the 2600 Series Adapter, which frees
space in upper memory. If you are booting
from a Fibre Channel disk drive attached to
the 2600 Series Adapter, you must enable
this setting. See “Selectable Boot Settings”
on page 2-5 for details on specifying the boot
device.
Frame Size 512/1024/
2048
2048 This setting specifies the maximum frame
length supported by the 2600 Series Adapter.
Loop Reset
Delay
0–60 sec-
onds
5 seconds After resetting the loop, the firmware refrains
from initiating any loop activity for the number
of seconds specified in this setting.
Adapter
Hard Loop
ID
Enabled/
Disabled
Disabled If the Adapter Hard Loop ID setting is
enabled, the adapter attempts to use the ID
specified in the Hard Loop ID setting.
Hard Loop
ID
0–125 0 If the Adapter Hard Loop ID setting is
enabled, the adapter attempts to use the ID
specified in this setting.