Product Label

8
LAWN AND ORNAMENTALS
GENERAL APPLICATION INSTRUCTIONS
This product may be applied in the following areas to control a wide spectrum of insects
and mites:
• Interiorscapes (such as hotels, shopping malls, ofce buildings)
• Outdoor Plantscapes (such as around residential dwellings, ornamental gardens,
parks, institutional buildings, recreational areas, athletic elds and home lawns)
This product may be applied to the following plants:
Trees, Shrubs, Foliage plants, Non-bearing fruit and nut trees (that is, perennial crops that
will not produce a harvestable raw agricultural commodity during the season of application),
Flowers.
This product formulation mixes readily with water and other aqueous carriers. Use this prod
-
uct as a tank-mix with other pesticides, including insect growth regulators. If applying as a
tank mix, all precautions and limitations on each separate product label must be followed.
Tank Mix Compatibility Testing: A jar test is recommended prior to tank mixing to ensure
compatibility of this product and other products. Use a clear glass quart jar with lid and mix
the tank mix ingredients in their relative proportions. Always use water from the intended
source. Invert the jar containing the mixture several times and observe the mixture for ap
-
proximately ½ hour. Evaluate the solution for uniformity and stability. If the mixture balls-up,
forms akes, sludges, gels, oily lms or layers, or other precipitates, it is not compatible and
the tank mix combination should not be used.
Tank Mix Preparation: To prepare a new tank mix, add the products listed to the tank mix
in the order given. After addition of each product, agitate the tank mix before adding the
next product: (1) wettable powders; (2) liquids and owable concentrates; (3) emulsiable
concentrates.
This product is an insecticide. Any insect/mite population may contain individual insects that
may develop resistance to a specic pesticide product used in consecutive generations to
control these pests. Prediction of resistance development is uncertain. Appropriate resis
-
tance management strategies should be followed. Contact your local extension specialist or
certied crop advisors for any additional pesticide resistance management and/or Integrat
-
ed Pest Management recommendations for the specic site and pest problems in your area.
In the State of New York, for application uses outdoors on ornamentals and lawns in
landscaped areas around residential, institutional, public, commercial and industrial
buildings, parks, recreational areas and athletic elds:
The Following Precautionary Measures Must be Obeyed.
A 100-foot buffer must be maintained between the application site and waters of
the State. A 100-foot buffer is required for all water except those entirely privately
owned with no outlet to State waters. The buffer must consist of well maintained,
established vegetation (i.e., grass, etc.) growth and must be maintained to prevent the
development of channels.
In New York State, do make a single repeat application of this product if there are signs
of renewed insect activity, but no sooner than two weeks after the rst application.
LAWNS: Apply this product as a broadcast treatment in volumes of up to 10 gallons per
1000 square feet for uniform coverage of grass foliage.
If applications are made in spray volumes of less than 2 gallons per 1000 square feet, im
-
mediately irrigate the treated area with at least 0.25 inches of water to ensure the product
reaches pests below the grass.
LAWN APPLICATION RATES
Follow the application rates in the table below. Under typical conditions, excellent control
of these pests can be achieved. If maximum residual control is needed, the applicator may
apply this product at up to 1.0 . oz per 1,000 sq. ft. to control these pests.