Installation guide
at
java.lang.Thread.run(Thread.java:595)
Workaround: Choose one of the following workarounds.
■
Workaround 1: Follow these steps.
1. Shut down the system, then turn on the power again.
2. After the system starts up, insert the appropriate CD at the prompt. Although the CD is
inserted, no additional software is installed on the system. In a moment, the system
reboots normally.
■
Workaround 2: Follow these steps.
1. Open a terminal window.
2. Log in as superuser.
3. Create or modify access to the .instsuccess le.
# touch /tmp/.instsuccess
4. Stop the Java process.
# pkill -9 java
The system reboots without prompting for the CD media.
x86: System Fails to Boot After Custom JumpStart
Installation (6205478)
If you use the Custom JumpStart installation method to install on an x86 based system, and
explicitly congure slice 2 as the overlap slice in the prole, an error occurs. The system does
not reboot successfully after the installation is completed. The following error message is
displayed:
Cannot find Solaris partition
This failure occurs because the overlap slice 2 (c0t0d0s2, for example) is set to begin at cylinder
1 rather than cylinder 0.
Workaround: In the Custom JumpStart prole, remove the lesys keyword entry that
congures slice 2 as the overlap slice. For example, you would remove a keyword entry that is
similar to the following entry.
filesys c0t0d0s2 all overlap
After you remove the entry, perform the Custom JumpStart installation.
Installation Bugs
Chapter 1 • Installation Issues 37