Installation guide

7.5 Gate Daemon Configuration Guide
References to the Gate Daemon Configuration Guide in the Technical
Overview and possibly other books are obsolete because this document has
been removed from the Tru64 UNIX 4.0F Documentation CD–ROM.
Information from the Gate Daemon Configuration Guide has been
incorporated into the following reference pages: gated.conf(4),
gated.control(4), gated.proto(4), gated_intro(7), and
gated(8).
7.6 System Configuration and Tuning Guide
In prior releases, reference information about kernel subsystem attributes was
found in Appendix B of the System Configuration and Tuning Guide.
Starting with Version 4.0F, reference information about subsystem attributes
resides in the reference pages. See sys_attrs(5) for more information.
Note that the current set of reference pages for subsystem attributes includes
more subsystems than were formerly covered in the book appendix; however,
there are still subsystems with attributes that do not have reference pages.
This omission will be addressed in a future release of the product.
The following errors exist in the sys_attrs_ufs(5) reference page:
• The default value for the inode-hash-size attribute is listed as 2048.
The correct default value is 512.
• The default value for the ufs-blkpref-lookbehind attribute is
listed as 16. The correct default value is 8.
7.7 Guide to Preparing Product Kits
The following information should be included in the Guide to Preparing
Product Kits.
If you are developing an Asynchronous Hardware kit for Version 4.0F, you
must ship symbolic links from the /sys/BINARY directory to every kernel
module in your kit. In Version 4.0F, the kernel build process searches only
the /sys/BINARY directory. As a result, symbolic links from the
/sys/BINARY directory to your kernel module must be shipped in the same
subset.
The following corrections should be made to Appendix A of the Guide to
Preparing Product Kits.
Documentation Notes 7–5