User`s guide

Appendix B - Installation
EK-TL891-UG .A01 B-9
b) Using mounting screws (P/N 213164-108), mount the slide bracket
assembly using the two mounting holes marked 2, 3, or 4 to mount
the second, third or fourth module respectively. Start by mounting
the slide/bracket assembly to the rear of the StorageWorks cabinet.
Hold the bracket/slide assembly in place with one hand, fasten the
mounting screw to the bracket holes marked with a number that
corresponds to the module number.
c) Be careful to mount all four brackets at the same height. You can
use a ruler or count the hole numbers to achieve this.
d) Tighten all four corners and the slide extension.
Figure B-4 Metric Rackmount Installation Layout