User`s guide

DLT MiniLibrary (TL891) - User’s Guide

B-8 EK-TL891-UG. A01

Metric Rackmount Procedure:

Reference Figure B-4

Metric Rackmount Installation Layout

. Mount the

appropriate metric conversion bracket to both ends of the slide using the 10-

32 nuts provided in the slide kit. Do this for both the left and right slide

assembly. For modules 1 and 2, use P/N 968313-101. For modules 3 and 4,

use P/N 968320-101. Make sure that these brackets are oriented so that the

numbers are right side up in all corners.

2. Mounting the bracket/slide assembly to the StorageWorks:

I. If installing the first module, select a mounting location.

a) Mount each slide/bracket assembly to the rack by aligning the two

mounting holes marked #1 to holes on the rack. Start by mounting

the slide/bracket assembly to the

rear

of the StorageWorks first.

Hold the bracket/slide assembly in place with one hand, fasten a

mounting screw to the holes marked #1.

b) To mount the front bracket, place bracket (P/N 968312-101)

front

of the rack with the holes marked #1 aligned to the holes on

the rack.

c) Extend the slide/bracket assembly forward to mate with the rack.

Align the holes marked #1 on the slide/bracket assembly with the

hole #1 on the front bracket and fasten two mounting screws

through the two #1 holes.

d) Be careful to mount all four brackets at the same height. You can

use a ruler or count holes to achieve this.

e) Tighten all four corners and the slide extension.

I. Procedure for installing modules 2, 3, or 4:

b) Each unit is 7 inches high. To locate the mounting location of the

next bracket/slide assembly, use a ruler to measure 7 inches vertical

distance of the protruding stud from the bracket above to the stud of

the bracket which is to be installed. The mounting holes marked for

the number of the module being installed should automatically line

up with the rack holes.