User`s guide

DLT MiniLibrary (TL891) - User’s Guide
4–4 EK–TL891–UG. A01
Example:
To set the DLT1 Density would involve the following steps:
1. With the
next to line 1, press the
Enter button, moving the
to line 2.
Notice the
appears at the end of line 4.
2. Use the
and buttons to scroll line 2 to display the possible settings.
After making your selection, press the Enter button to save the new
selection. You can return to the screen in Figure 4-5 by pressing the Escape
button. The
returns to line 1.
3. This time, if you press the
button instead of the Enter button, the
moves to line 3, allowing you to set DLT1 Compression.
4. Press the Escape button repeatedly until the submenu in Figure 4-4
reappears.
5. Repeat this procedure for each configuration option you want to change.
4.2 Descriptions of Configuration Options
The items available on the Configuration Menu are as follows:
4.2.1 Set Data Format
This option enables you to specify DLT data Density and DLT data Compression
requirements. The default for both options is Auto Selection (this will not affect
the default operation of the TZ89N Tape Drive).
4.2.2 Set SCSI
This option enables you to 1) enable or disable the library robotics SCSI bus
parity checking, and 2) set the SCSI addresses of the drives and the library
robotics. The defaults are: parity on; DLT 0 address = 4; DLT 1 address = 5,
robotics address = 0.