User`s guide

DLT MiniLibrary (TL891) - User’s Guide
3–4 EK–TL891–UG. A01
Figure 3–4 Cleaning Confirmation Screen
Clean: DLT0
Use: Slot0
ENTER To Execute
ESCAPE To Cancel
6. As the confirmation screen indicates, to execute the cleaning operation,
press the
Enter
button. If the confirmation screen does not show your
intended drive and cleaning cartridge, press the
Escape
button to return to
the Cleaning submenu.
When you press the
Enter
button, the In Progress screen appears.
Figure 3–5 Cleaning In Progress Screen
Clean: DLT0
Use: Slot0
Cleaning In Progress
When the cleaning operation is completed, the Default Screen reappears.
3.1.3 Removing the Cleaning Cartridge
NOTE
If the Base Module is installed in a sufficiently
secure area, you may elect not to use the
Magazine Security Lock. In that event, leave the
lock in the unlocked position
1. Examine the Default Screen on the Control Panel to determine whether
any cartridges are loaded into the drives. If so, then unload each using
the Load/Unload Menu, as described in
Chapter 2 - Operation
.
2. Using the key provided (if necessary), Unlock the Magazine Security
Lock on the front panel.
3. Press the
Unlock/Open
Button on the front panel.