User`s guide

DLT MiniLibrary (TL891) - User’s Guide
3–2 EK–TL891–UG. A01
CAUTION
The cleaning cartridge is abrasive, and should not
be used unless the
Use Cleaner
LED comes on.
To determine which drive requires cleaning on
two-drive models, unload both drives and select
‘Cleaning Needed’ on the Drive Status submenu of
the Show Status menu.
3.1.1 Installing a Cleaning Cartridge
1. Examine the Default Screen on the Control Panel to determine whether
any cartridges are loaded into the drives. If so, then unload each as
described in Chapter 2 - Operation.
2. Using the key provided (if necessary), unlock the Magazine Security
Lock on the front panel.
3. Press the
Unlock/Open
Button on the front panel.
4. Remove the magazine from the Base Module.
5. Remove any cartridge present in Slot 0 (the slot farthest from the
handle).
6. Insert the cleaning cartridge into Slot 0. You can use any slot, but using
Slot 0 saves some keystrokes.
7. Press the
Unlock/Open
button on the front panel.
8. Insert the magazine into the Base Module.
3.1.2 Running the Cleaning Cartridge
This procedure assumes that the cleaning cartridge has been installed into Slot 0
of the magazine.
1. At the Default Screen, press the
Enter
button. The display will show
the following.