User`s guide

Chapter 2. Operation
EK–TL891–UG. A01 2–-23
Figure 2-20 Load/Unload ‘From’ Entry Screen
When you have scrolled to your desired source, press the
Enter
button to select
it. Notice that in Figure 2-21, two changes occur in the display.
The * reappears at the beginning of line 2, indicating that you have made a
selection.
The
now moves to line 4, indicating that you may now select a destination.
Figure 2-21 Load/Unload ‘To’ Entry Screen
You can now simply press the Enter button to select DLT0 as the destination.
Note that there is no
at the end of line 4, nor at the end of line 1. There are
no additional choices because 1) you have selected a slot as the source, so the
destination must be a drive, and 2) DLT1 already has a cartridge in it, so it
cannot be a valid destination. Press the Enter button to select DLT0. In response,
the confirmation screen in Figure 2-22 appears.
From:
Slot4
To:
*DLT1
From:
*Slot4
To:
*DLT0