User`s guide

English 5

Part Number: 157254-001- Writer: Marianne Silvetti - Saved by: MSilvetti

Saved date: 10/12/99 6:16 PM

File Path: P:\Docs\Monitors\Aoki

Connecting the DVI-D Cable

To connect the DVI-D (Digital Visual Interface-Digital) cable to the

DVI-I (Digital Visual Interface-Integrated) connector on the back of

the monitor, you must first remove the monitor base cover and the

monitor back panel and disconnect the DVI-I connector.

CAUTION:

Before beginning to disassemble the monitor, be

sure the monitor is turned off and the power and signal

cables are both disconnected

✎

The DVI-D cable supplied with this monitor is for digital

to digital connection only. Your computer must have a

DVI-compatible graphics card installed for use with this

cable. When connecting the DVI-D signal cable to the

DVI connector on the monitor, you must connect the other

end of the DVI-D cable to the DVI connector on the

computer.

To remove the monitor base cover and back panel, complete the

following steps:

1. Lay the front bezel down on a soft area to prevent it from

getting scratched, defaced, or broken.

2. Remove the cover

from the monitor base by placing your

fingers in the opening on the bottom of the base and pulling

upward, then pulling out to remove the cover.

3. Remove the back panel

from the monitor by pushing the

bottom tabs upward and pulling out to remove the panel.