User Guide
Table Of Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
Removal and Replacement Procedures
Maintenance and Service Guide 5–29
13. Release the ZIF connector 1 to which the LED board cable is
attached and disconnect the LED board cable
2 from the
system board (Figure 5-24).
14. Remove the four PM2.0 × 5.0 screws that secure the system
board to the base enclosure. The screws are located in the
following locations:
❏ Next to the pen holder spring clip 3
❏
Directly behind the USB connectors 4
❏
Directly behind the external monitor connector 5
❏
Left side of the heat sink grille 6
Figure 5-24. Removing the System Board Screws