User Guide
Table Of Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
Removal and Replacement Procedures
Maintenance and Service Guide 5–23
5.7 Digitizer Cable
✎
The digitizer cable is included in the Miscellaneous Cable Kit,
spare part number 310673-001.
Perform the following steps to remove the digitizer cable:
1. Prepare the tablet PC for disassembly (Section 5.3).
2. Remove the display panel assembly (Section 5.5).
3. Disconnect the digitizer cable
1 from the system board
(Figure 5-19).
4. Remove the digitizer cable from the clips in the heat sink 2.
5. Remove the digitizer cable from the base enclosure
3.
Figure 5-19. Removing the Digitizer Cable
Reverse the preceding procedures to install the digitizer cable.