User manual

HP ThinState Deploy

To perform a ThinState deployment:

1. Set the boot order in the F10 System BIOS to USB boot (if necessary).

2. Attach the USB flash drive to the thin client unit you wish to deploy the captured image or system

settings to, and then power on the unit.

3. Follow the on-screen instructions. You can deploy the captured image or settings in one of the

following ways:

●

Upload to an FTP server or Windows file share

●

Save to a USB flash drive

●

Have the thin client host the settings or full image for other units to pick up using System

Update (If you are using this option, you do not need the USB flash drive.)

After you remove the USB flash drive and cycle power to the system, the image unbundles. Do not

interrupt or cycle power to the unit during this process.

You may use the captured image (flash.dd) found in the USB flash drive in combination with Altiris

Deployment Solution to remotely image multiple thin client units.

NOTE: You must use flash.ibr in conjunction with the HP ThinState Deploy utility (e.g., ibr.exe).

Flash.dd is not compatible with the Altiris rdeploy.exe or rdeployt.exe utilities. Please consult the HP

Compaq Thin Client Imaging Tool at:

http://h20000.www2.hp.com/bc/docs/support/

SupportManual/c00485307/c00485307.pdf.

For more information about Altiris, see http://www.altiris.com/.

Internet Options

The Internet Settings dialog box allows you to configure Internet browser settings on the terminal.

Internet Options