Operating instructions

3
A. Unpacking the Array
4. Remove all of the disk drives from
the array (see Fig. 7).
CAUTION! Do NOT stack disk
drives; damage to disk drives may
occur if they fall.
Fig. 7. Removing a disk drive
5. Place the disk drives on the
antistatic mat (see Fig. 8).
CAUTION! Do NOT mix disk drives
among arrays. Disk drives must be re-
installed into the same array from
which they were removed.
Fig. 8. Placing disk drives on the antistatic mat
6. Loosen the captive screws on the
power modules and remove the
power modules (see Fig. 9,
A and B).
7. Back up all file systems and data.
8. Shut down the host system.
Fig. 9. Removing a power module
A
B