Installation guide

8 Compaq StorageWorks Fibre Channel SAN Switch 16 Release Notes
Telnet Command
qlPortShowAll
The qlPortShowAll command displays the following QuickLoop port
information for each port:
QuickLoop Mode
EnabledQuickLoop mode enabled
DisabledQuickLoop mode disabled
Looplet State
OnlineCompleted loop initialization
LippedNL_port lipped
LippingFL_port lipped
InitializingLoop initialization in progress
BypassedLooplet being bypassed
ErrorError found in this looplet
OfflineLooplet offline
FabricOLD_PORT state
Not in QuickLoop ModePort is not in QuickLoop mode
ssn
The Fibre Channel SAN Switch has a software readable serial number that can
be accessed by using the Telnet command ssn. Switches that have been
upgraded to firmware v2.1.7 will not display the software readable serial
number when this command is given, instead the switch World Wide Name
(WWN) will display. If you have a switch with firmware v2.1.7 preinstalled
and the switch displays the WWN instead of the software readable serial
number, contact customer service.