Technical data

Maintenance Procedures 65

d. Specify the new IP address by entering the following:

ipAddrSet

e. Enter the following information at the corresponding prompts:

–

Ethernet IP Address [current]:

Enter new Ethernet IP

address (the default is 10.77.77.77).

–

Ethernet Subnetmask [current]:

Enter new Ethernet

subnetmask (the default is 0.0.0.0).

–

Fibre Channel IP Address [current]:

Enter new fibre

channel IP address if desired.

–

Fibre Channel Subnet Mask [current]:

Enter new fibre

channel subnet mask if desired.

–

Gateway Address [current]:

Enter new gateway address

(the default is 172.17.1.1).

–

Set IP address now? [y = set now, n = next

reboot]:

Enter “

” to set the IP address now by rebooting the

switch.

f. You can verify the address was correctly set by entering the following:

ipAddrShow

12.Log on with administrative privileges to the new switch, using a Telnet

connection.

13.From a computer workstation, disable the diagnostic tests that run after

each reboot by entering the following at the Telnet prompt:

diagDisablePost

14.Set the domain ID to the value used by the previous switch, if still

available.

The default domain IDs on the six original switches shipped with the FC

6164 are (starting with switch 1) 231, 232, 233, 234, 235, and 236.