Technical data

52 HP Surestore FC Switch 6164 Installation and Reference Guide

e. Open and configure a terminal emulator application (such as

HyperTerminal on Windows 95 or NT, or TERM in a UNIX

environment) as follows:

f. From the terminal emulator application, log on to the first switch

through the serial connection.

g. Specify the new IP address by entering the following:

ipAddrSet

h. Enter the following information at the corresponding prompts:

–

Ethernet IP Address [current]:

Enter new Ethernet IP

address (the default is 10.77.77.77).

–

Ethernet Subnetmask [current]:

Enter new Ethernet

subnetmask (the default is 0.0.0.0).

–

Fibre Channel IP Address [current]:

Enter new fibre

channel IP address if desired.

–

Fibre Channel Subnet Mask [current]:

Enter new fibre

channel subnet mask if desired.

–

Gateway Address [current]:

Enter new gateway address

(the default is 172.17.1.1).

–

Set IP address now? [y = set now, n = next

reboot]:

Enter “

” to set now by rebooting the switch.

i. You can verify the address was set correctly by entering the following:

IPaddressShow

Parameter Value

Bits per second: 9600

Databits: 8

Parity: None

Stop bits: 1

Flow control: None

Function arrows and Ctrl keys act as: Terminal keys

Emulation: Autodetect