Technical data

Installing and Configuring the FC 6164 49
17.Install the front bezel:
a. Orient the front bezel so that its outer surface is facing you.
a. Align the bottom end of the front bezel with the bottom edge of the
rail tray (see Figure 20). There are two alignment posts and two spring
clips on each side of the bezel that grip the rack uprights and hold the
bezel in position. Each of the lower alignment posts fits into the second
unused hole above the front mounting flange on each side of the rail
tray.
b. Press the sides of the bezel against the rack uprights until the bezel
snaps into place. Snap the bottom end in first and then the top end.
c. Inspect the bezel to ensure that it is installed so that its top edge is
aligned with the top surface of the switch.
Figure 20. Installing the Front Bezel