Technical data

Installing and Configuring the FC 6164 47
15.Assemble the plenum:
a. Position the bottom panel of the plenum on a flat surface with the two
folded ends facing up (see Figure 18).
b. Remove the paper backing from one of the adhesive strips on one of
the plenum side panels, and carefully position the side panel against
the inner surface of one of the folded ends of the bottom panel (see
Figure 18). Press the side panel firmly against the upright end of the
bottom panel to ensure that the adhesive strip on the side panel makes
full contact with the end of the bottom panel. You can use a screwdriver
handle to increase the pressure you apply when joining the parts.
c. Repeat Step 15b for the other side panel.
d. Remove the paper backing from the adhesive strips on the upper ends
of both plenum side panels.
Figure 18. Assembling the Plenum
Bottom of
plenum
Adhesive
strips
Adhesive
strips
Adhesive
strips