Technical data

Installing and Configuring the FC 6164 43
11.If you inserted the switch into the rack from the back, skip this step.
Reinstall the removed hardware:
a. Use the 16 #10-32 Phillips screws you removed in Step 9 to re-attach
the rack-mounting flanges to the switch (see Figure 14).
b. Use the two screws you removed in Step 8 to re-attach the latch plate
(see Figure 14). Make sure that there is a gap of approximately
3/16-inch between the edges of the latch plate and the edges of the
cutout in the rack-mounting flange.
c. Orient the hinge plates so that the sides that have the loops face each
other (see Figure 15). Use the eight #6-32 x ¼-inch flat-head screws
you removed in Step 7 to re-attach the hinge plates to the left side of
the switch at the front end (see Figure 13).
Figure 15. Orienting the Hinge Plates Prior to Reinstallation
Loops