Technical data

Installing and Configuring the FC 6164 35
c. Install Tinnerman nuts for the top holes of RU-1 in both of the rack’s
front uprights (see Figure 7).
Note
The Tinnerman nuts used for the two types of racks (HP and
Compaq/Rittal) are of different styles and different sizes. Refer to
Figure 5 and Figure 7 to identify the correct Tinnerman nut to use with
the rack you are installing the switch in.
d. For a Compaq/Rittal rack, insert spacers in the holes immediately
below the Tinnerman nuts you inserted in Step 3c (see Figure 7).
Figure 7. Installing Tinnerman Nuts and Spacers on the Front Uprights
Inner surface of
Compaq/Rittal
rack
Spacer
Tinnerman
nut
Outer surface of
HP rack