Technical data

169
Following is a description of the fields on the SNMP Admin tab.
System Description Displays or sets system description. Default is Fibre
Channel Switch.
System Location Displays or sets location of switch. Default is End
User Premise.
System Contact Displays or sets contact information for switch.
Default is Field Support.
Event Trap Level Sets severity level of switch events that prompt
SNMP traps. Default is 0.
Enable
Authentication
Traps
Click on to enable authentication traps; click off to
disable (recommended).
Read Write
Community String
Displays or sets up to three strings that work with the
SNMP
set
command.
Read Only
Community String
Displays or sets up to three strings that work with the
SNMP
get or get-next
command.
Read Write and
Read Only Trap
Recipients
Displays or sets recipients for traps (usually IP
address of SNMP management station).
Commit SNMP
Changes
Click to apply changes made.
Reset Click to reset all fields to values present when SNMP
Administration was launched.
Note
To disable the community string or trap recipient fields, leave them
empty.