Technical data

Using Fabric Manager 125
Rename Cfg Click to edit the name of the configuration selected in
the Config Name field.
Zone/QLoop
Selection List
A list of the zones and QuickLoops available to add to
the configuration.
Add Member Click to add the switch selected in the Zone/QLoop
Selection List to the Configuration Members list.
Remove
Member
Click to remove the selected member from the
[Configuration name] Members list.
[Configuration
name] Members
The members of the configuration selected in the Config
Name field. The name of this list depends on the
selection. Only one configuration can be enabled at a
time; if none are enabled, zoning is not active in the
fabric.
Enable Config Check to enable the configuration selected in the Config
Name field, or uncheck to disable it.
Config to
enable
Displays the name of the configuration that is currently
selected for enabling. This configuration can be enabled
by clicking Apply.
Config
currently
enabled
Displays the name of the currently enabled
configuration. Only one configuration can be enabled at
a time.
Apply Click to apply all changes made since Zone
Administration View was opened, including changes
made on other tabs in the view. Changes cannot be
cancelled after they are applied.
Cancel Click to cancel all changes since they were last applied,
and to exit Zone Administration View. Changes cannot
be cancelled after they are applied.
Done Click to apply all changes made since Zone
Administration View was opened, and to exit Zone
Administration View.