Installation guide

Command View XP installation guide 39
•Enter rpm -Uvh /mnt/cdrom/RedHat/RPMS/rsh-ser*. You may need to mount your
CD-ROM if the OS cannot find the directory. The command mount /dev/cdrom should work.
3. Verify that the rexec service is started.
•Enter ntsysv at the command prompt.
• Check the rexec and rsh services and click OK.
• Restart the service by entering service xinetd restart.
•Edit /etc/pam.d/login. Comment out (add “#” to the line):
# auth required /lib/security/pam_securetty.so
•Edit /etc/pam.d/rexec. Comment out (add “#” to the line):
# auth required /lib/security/pam_securetty.so
•Edit /etc/pam.d/ftp. Comment out (add “#” to the line):
# auth required /lib/security/pam_listfile.so item=user sense=deny
file=/etc/ftpusers onerr=succeed
• Restart the service by entering service xinetd restart.
4. Configure the root/superuser account to allow remote access via the exec/rexec and FTP services.
•Run the /usr/sbin/ntsysv command and enable wu-ftpd.
•Edit /etc/pam.d/ftp by commenting out the following line with #:
auth required /lib/security/pam_listfile.so item=user sense=deny
file=/etc/ftpusers onerr=succeed
•Edit /etc/ftpusers by removing or commenting out the following line with #:
root
•Edit /etc/ftpaccess as follows:
Change allow-uid ftp to allow-uid ftp root.
Change allow-gid ftp to allow-gid ftp root.
•Run the /sbin/service xinetd restart command.
Installing host agents with the remote deployment tool
NOTE: If Performance Advisor XP 2.1 is installed on the same management station as Command View
XP, the remote deployment tool installs both the Command View Path Connectivity and Performance
Advisor XP host agents on the target hosts.
Designating a single host
1. Launch the remote deployment application by clicking Start > Programs > HP StorageWorks > Host
Agent Deployment Tools > Install Host Agent.
2. Add a single host by entering the host name or IP address, admin user name, and password.
3. Click Add Host.
Designating multiple hosts
1. Launch the remote deployment application by clicking Start > Programs > HP StorageWorks > Host
Agent Deployment Tools > Install Host Agent.