Technical data

Setting the host mode and host group mode for the disk array ports

After the d isk array is installed, you must set the host m o de for each disk array por t to match the h ost

OS. Set the host mode using LUN M anager in Remote Web Console XP (shown), Command View XP,

or Command View XP Advanced Edition. For procedures, refer to the applicable user guide available

at h

ttp://www.hp.com/support/manuals. If these are not available, the HP service representative

can set the h

ost mode using the SVP.

The require

d host mo d e setting for Tru64 is 07.

CAUTION:

The correct host mode must be set for all new installations (newly connected ports) to Tru64 hosts. Do not

select a mode other than 07 for Tru64. Changing a host mode after the host has been connected is

disruptive and requires the server to be rebooted.

When a new host group is added, additional host group modes (options) may be con ﬁgured. The

storage administrator must verify if an additional host group mode is required for the host group.

Installation