Technical data

6.8.3.1
Installing the KGPSA PCI-to-Fibre Channel Adapter
Module .... .... ... .............................................
6–36
6.8.3.2
Setting the KGPSA-BC or KGPSA-CA to Run on a
Fabric .........................................................
6–37
6.8.3.3
Setting the KGPSA-CA Adapter to Run in a Loop . ... . 6–39
6.8.3.4
Obtaining the Worldwide Names of KGPSA Adapters 6–41
6.8.4
Setting Up the HSG80 Array Controller for Tru64 UNIX
Installation .... ... .... .............................................
6–42
6.8.4.1
Setting Up the HSG80 Array Controller for Arbitrated
Loop . ..........................................................
6–48
6.8.4.2
Obtaining the Worldwide Names of HSG80 Controller 6–50
6.9
Installing Tru64 UNIX and TruCluster Server Software Using
Fibre Channel Storage . ..............................................
6–51
6.9.1
Before You Install .. . .............................................
6–53
6.9.1.1
Configure the HSG80 Storagesets .. ..... ................. 6–53
6.9.1.2
Adding Units and Identifiers to the HSG80
Storagesets .. .... .............................................
6–56
6.9.1.3
Set the Device Unit Number . . ............................. 6–61
6.9.1.4
Displaying the Available Boot Devices .. . ................ 6–66
6.9.1.5
Set the bootdef_dev Console Environment Variable for
Tru64 UNIX Installation .. .... ............................. 6–67
6.9.2
Install the Base Operating System ............................ 6–69
6.9.3
Determining /dev/disk/dskn to Use for a Cluster
Installation .... ... .... .............................................
6–69
6.9.4
Label the Disks to Be Used to Create the Cluster . ..... .... 6–71
6.9.5
Install the TruCluster Server Software and Create the
First Cluster Member .... .... ..... .............................. 6–71
6.9.6
Reset the bootdef_dev Console Environment Variable .. ... 6–72
6.9.7
Add Additional Systems to the Cluster . ..... ................. 6–74
6.10
Converting the HSG80 from Transparent to Multiple-Bus
Failover Mode ......................................................... 6–76
6.10.1
Overview .......................................................... 6–76
6.10.2
Procedure to Convert from Transparent to Multiple-bus
Failover Mode .. ..... .............................................. 6–77
6.11
Using the emx Manager to Display Fibre Channel Adapter
Information .. .......................................................... 6–81
6.11.1
Using the emxmgr Utility to Display Fibre Channel
Adapter Information ............................................. 6–82
6.11.2
Using the emxmgr Utility in an Arbitrated Loop Topology 6–84
6.11.3
Using the emxmgr Utility Interactively ... ................... 6–85
Contents vii