Technical data

HSZ50 controller, 10–25
in BA356, 10–11
in UltraSCSI BA356
, 10–13
KZPBA-CB, 4–17
RAID subsystem controllers
, 10–25
requirement, 3–6
setting, 4–9t, 4–17, 8–25, 9–17,
10–17
UltraSCSI BA356, 10–13, 10–17
SCSI targets
number of
, 2–8
SCSI terminators supported, 2–16
SCSI-2 bus, 3–6
SCSI_VERSION
SCSI-2
, 6–45
SCSI-3, 6–45
selecting BA356 disk SCSI IDs
,
10–11
selecting UltraSCSI BA356 disk
SCSI IDs
, 10–13
set bootdef_dev command, 6–68,
6–73, 6–76
SET FAILOVER COPY =
THIS_CONTROLLER command
,
1–15
set ffauto command, 6–73
set ffnext command, 6–73
set hp_count command, 7–10
set hp_qbb_maskn command, 7–10
SET MULTIBUS_FAILOVER
COPY = THIS_CONTROLLER
command
, 3–18
set scm_csb_master_eligible
command
, 7–12
setting bus speed
KZPSA-BB
, 9–17
setting SCSI ID
20/40-GB DLT Tape Drive
, 8–11
40/80-GB DLT Drive, 8–15
DS-TZ89N-TA tabletop tape drive,
8–10
DS-TZ89N-VW SBB tape drive, 8–7
ESL9326D enterprise library
, 8–75
KZPBA-CB, 4–17, 9–16
KZPSA-BB, 9–17
MUC, 8–52
TL881/891 DLT MiniLibrary
, 8–62,
8–72
TL891 tape library
, 8–24
TL892 tape library
, 8–24
TL893 tape library
, 8–52
TL894 tape library, 8–38
TL896 tape library, 8–52
TZ885 minilibrary, 8–18
TZ887 minilibrary, 8–21
TZ88N-TA tabletop tape drive
, 8–6
TZ88N-VA SBB tape drive
, 8–2
shared SCSI bus requirements
externally teminated
configurations
, 10–2
radial configurations with
non-UltraSCSI hardware
, 10–2
radial configurations with
UltraSCSI hardware
, 3–1
shared SCSI buses, 4–3
adding devices, 10–6
assigning SCSI IDs, 3–6
cable length restrictions
, 3–7
connecting devices, 3–8, 10–6
device addresses, 3–6
differential, 3–4
number of, 2–6, 4–3
requirements, 3–2
single-ended, 3–4
using trilink connectors, 10–6
using Y cables, 10–6
shared storage
BA350 storage shelf
, 10–15
increasing capacity, 4–2, 4–3
non-UltraSCSI BA356 storage
shelf
, 10–15
RAID subsystem array controller,
10–25
Index–11