Technical data

SBB, 3–10
SCSI ID, 3–10
termpwr, 3–9
transfer rate, 2–13
DS-TZ89N-TA tabletop tape drive
cabling
, 8–10
setting SCSI ID
, 8–10
DS-TZ89N-VW SBB tape drive
cabling
, 8–9
setting SCSI ID, 8–7
dual-redundant controllers
, 1–14
DWZZA signal converter
incorrect hardware revision
, 2–12
termination, 10–3, 10–16
upgrade, 2–13
DWZZB signal converter
termination
, 10–3, 10–16
DWZZH-03
(
See DS-DWZZH-03 UltraSCSI
hub )
DWZZH-05
( See DS-DWZZH-05 UltraSCSI
hub )
E
eight-node cluster
, 1–20
cabling first two nodes
, 11–5
cabling second shared SCSI bus,
11–9
cabling third shared SCSI bus,
11–12
requirements, 11–3
using Fibre Channel, 11–1
using shared SCSI
, 11–1
EMA12000 Enterprise Modular
Array
configuring
, 2–9
port configuration, 2–9
transparent failover mode, 2–9
unit configuration, 2–9
emxmgr command
-d
, 6–82
displaying adapters, 6–82
displaying target ID mapping
, 6–82
displaying topology
, 6–82, 6–84
-m, 6–82
-t, 6–82, 6–84
use, 6–82, 6–83, 6–85
using interactively
, 6–85
enterprise library
( See ESL9326D Enterprise
Library tape drive )
ESA12000 Enterprise Storage
Array
configuring
, 2–9
port configuration, 2–9
replacing controllers of
, 6–51
transparent failover mode, 2–9
unit configuration, 2–9
ESL9000 series tape library
( See ESL9326D Enterprise
Library tape drive )
ESL9326D Enterprise Library
tape drive
cables
, 8–77
cabling, 8–74, 8–77
capacity, 8–74
firmware, 8–75
internal cabling, 8–76
number of drives
, 8–74, 8–75
part numbers, 8–74
SCSI connectors, 8–77
setting SCSI ID
, 8–75
tape cartridges, 8–74
tape drives, 8–74, 8–75
termination, 8–77
upgrading, 8–74
F
F_Port fabric port, 6–4
fabric, 6–3, 6–5
failover mode
changing
, 6–77
multiple-bus, 6–77
set nofailover, 6–78
transparent, 6–77
Index–4