Technical data

Table 9–3: Installing a KZPSA-BB or KZPBA-CB for Use with External
Termination (cont.)
Step
Action Refer to:
7
Use the show pk* or show isp* console
commands to determine the status of the
KZPSA-BB or KZPBA-CB console environment
variables, and then use the set console
command to set the KZPSA-BB bus speed to
fast, termination power to on, and the KZPSA
or KZPBA-CB SCSI bus ID.
Section 9.1.4.1 through
Section 9.1.4.3 and
Example 9–6 through
Example 9–9
_____________________ Notes _____________________
Ensure that the SCSI ID that you use is distinct from all other SCSI IDs
on the same shared SCSI bus. If you do not remember the other SCSI
IDs, or do not have them recorded, you must determine these SCSI IDs.
You will have problems, such as not being able to access devices, if
you have two or more SCSI adapters at the same SCSI ID on any one
SCSI bus.
8
Repeat steps 1 through 7 for any other KZPSA-BBs
or KZPBA-CBs to be installed on this shared
SCSI bus on other member systems.
—
9
Install the remaining SCSI bus hardware needed
for storage (DWZZA(B), RAID array controllers,
storage shelves, cables, and terminators).
Section 10.4
BA350 storage shelf Section 10.3.1,
Section 10.4.1.1, and
Section 10.4.3.1
Non-UltraSCSI BA356 storage shelf Section 10.3.2.1,
Section 10.4.1.2, and
Section 10.4.3.2
UltraSCSI BA356 storage shelf Section 10.3.2.2,
Section 10.4.1.3, and
Section 10.4.3.3
HSZ40 or HSZ50 RAID array controller Section 10.4.4
RAID Array 3000 Section 10.4.5
10
Install the tape device hardware and cables
on the shared SCSI bus as follows:
Chapter 8
TZ88 Section 8.1
TZ89 Section 8.2
Compaq 20/40 GB DLT Tape Drive Section 8.3
TZ885 Section 8.5
TZ887 Section 8.6
9–8 Configuring Systems for External Termination or Radial Connections to Non-UltraSCSI Devices