Manualshelf

Technical data

ManualsBrandsCompaq ManualsHome building and DecorStorageWorks TM RAID Array 3000 Pedestal Storage Subsystem
291292293294295296297298299300
2. On the Enter Password screen, enter the operator password. The
default operator password is 1234. The lock icon is unlocked and shows
an O to indicate that you have operator-level security clearance.
3. On the Operator screen, press the Configure Library button. The
Configure Library screen displays the current library configuration.
____________________ Note _____________________
You can configure the library model number, number of
storage bins, number of drives, library SCSI ID, and tape
drive SCSI IDs from the Configure Library screen.
4. To change any of the configurations, press the Configure button.
5. Press the Select button until the item that you want to configure is
highlighted. For the devices, select the desired device (library or drive)
by scrolling through the devices with the arrow buttons. After the
library or selected drive is selected, use the Select button to highlight
the SCSI ID.
6. Use the arrow buttons to scroll through the setting choices until the
desired setting appears.
7. When you have the desired setting, press the Change button to save the
setting as part of the library configuration.
8. Repeat steps 5 through 7 to make additional changes to the library
configuration.
9. Place the library back at the user level of security as follows:
a. Press the lock icon on the vertical bar of the control panel.
b. On the Password screen, press the User button.
A screen appears informing you that the new security level has
been set.
c. Press the OK button. The lock icon appears as a locked lock and
displays a U to indicate that the control panel is back at User level.
10. Power cycle the tape library to allow the new SCSI IDs to take effect.
8.10.3 TL895 Tape Library Internal Cabling
The default internal cabling configuration for the TL895 tape library has
the library robotics controller and top drive (drive 0) on SCSI bus port 1.
Drive 1 is on SCSI bus port 2, drive 2 is on SCSI bus port 3, and so on. A
terminator (part number 0415619) is connected to each of the drives to
provide termination at the tape drive end of the SCSI bus.
8–46 Configuring a Shared SCSI Bus for Tape Drive Use