Technical data

Table 8–5: Hardware Components in the Configuration in Figure 8–6 (cont.)
Callout Number
Description
7
328215-00X, BN21K, or BN21L HD68 to HD68 cable
c
8
H885-AA trilink connector
9
189646-001 (0.9 meter; 2.95-foot cable) or 189646-002
(1.8 meter; 5.9-foot cable)
d
BN21K-01 or BN21L-01 (1-meter; 3.3-foot cable)
d
BN21K-02 or BN21L-02 (2-meter; 6.6-foot cable)
d
10
152732-001 LVD terminator
a
The maximum length of the BN38C (or BN38D) cable on one SCSI bus segment must not exceed 25
meters (82 feet).
b
The maximum length of the BN37A cable must not exceed 25 meters (82 feet).
c
The maximum combined length of these cables must not exceed 25 meters (82 feet).
d
The maximum length of this cable, or of two cables if two tape drives are daisy-chained, is 3 meters (9.8 feet).
8.5 Preparing the TZ885 for Shared SCSI Usage
The TZ885 Digital Linear Tape subsystems combine a cartridge tape drive
(TZ88) and an automatic cartridge loader. The TZ885 uses a removable
magazine.
The TZ885 uses a five-cartridge (CompacTape IV) minitape library
(magazine) with a 200-GB capacity (compressed). It is capable of
reading/writing at approximately 10.8 GB per hour.
As with any of the shared SCSI devices, the TZ885 SCSI IDs must be set
to ensure that no two SCSI devices on the shared SCSI bus have the same
SCSI ID.
The following sections describe preparing the TZ885 in more detail.
8.5.1 Setting the TZ885 SCSI ID
To set the TZ885 SCSI ID from the Operators Control Panel (OCP), follow
these steps:
1. Press and hold the Display Mode push button (for about 5 seconds) until
the SCSI ID SEL message is displayed:
SCSI ID SEL
SCSI ID 0
2. Press the Select push button until you see the desired SCSI ID number
in the display.
3. Press the Display Mode push button again.
8–18 Configuring a Shared SCSI Bus for Tape Drive Use