Technical data

4. Turn on power to the switch and log in. If the connection is correct, the
self-test results will be displayed. It takes 2 to 3 minutes for self-tests
to complete.
• DS-DSGGB-AA: The switch automatically connects to the host and
logs the user on to the switch as
admin when the self-tests terminate.
For subsequent logons, the default password is password.
• DS-DSGGC-AA/AB: Plugging in the DS-DSGGC-AA/AB switch
turns the power on. (There is no on/off power switch.) Log in as the
admin user. The password is password.
5. Enter the ipAddrSet command, then enter the IP address, subnet
mask, and gateway address (if necessary). For example:
admin> ipAddrSet
Ethernet IP Address [10.77.77.77]: 16.142.72.54
Ethernet Subnetmask [255.255.255.0]: 255.255.255.0
Fibre Channel IP Address [none]: none
Fibre Channel Subnetmask [none]: none
Gateway Address [172.17.1.1]: none
[ y = set now, n = next reboot ]: y
Fabric OS (tm) Release v2.1.7
login:
When you have completed setting the IP address and subnet mask,
disconnect the PC or terminal from the DS-DSGGB-AA or DS-DSGGC-AA/AB
switch.
6.8.1.2.4 Logging In to the Switch with a Telnet Connection
Before you telnet to a Fibre Channel switch, you must set the Ethernet IP
address and subnet mask.
______________________ Note _______________________
A serial port connection and a telnet session cannot both
be active (at the same time) with the DS-DSGGB-AA and
DS-DSGGC-AA/AB switch. The telnet session takes precedence
and the serial port session is aborted when the telnet session
is started.
You can use a telnet session to log in to the switch at one of three security
levels. The default user names, which are listed from lowest security level
to highest security level, are listed in Table 6–3.
6–32 Using Fibre Channel Storage