User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Operation and Management
77Modular SAN Array 1000 User Guide
6. Insert the new drive into the same bay as the drive just removed, sliding it in
as far as it will go 1.
Make sure the ejector lever 2 is in the full open position to ensure a correct
latch.
Figure 40: Inserting the new drive
7. Close the ejector lever against the front of the drive. The locking hinge must
be engaged behind the front panel of the unit.
8. Insert the drive completely to ensure that the drive is firmly engaged and that
the ejector lever is latched.
Caution: Data can be lost if the drive is not firmly seated.
The drive tray indicators light one at a time and then turn off together to indicate
that the system has recognized the new drive. In fault-tolerant configurations,
allow the replacement drive to be reconstructed automatically with data from the
other drives. While reconstruction is in progress, the online indicators flash.
2
1
230941-005_MSA1000_UG.book Page 77 Thursday, April 17, 2003 5:53 PM