User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Operation and Management
70 Modular SAN Array 1000 User Guide
Figure 33: Installing the battery pack
6. After the pack is hooked in position, swing the pack downward making sure
the bottom clip and two pegs line up with the holes in the Array Accelerator.
7. Make sure that the top hook 1 and bottom clip 2 on the battery pack are
securely attached to the Array Accelerator.
Figure 34: Securing the battery pack
Installation of the new battery pack is complete. Repeat for the other battery pack.
1
2
230941-005_MSA1000_UG.book Page 70 Thursday, April 17, 2003 5:53 PM