User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Operation and Management
61Modular SAN Array 1000 User Guide
Replacing Components
Caution: It is important to follow these instructions when replacing
components in the MSA1000. If the procedure is done improperly, it is
possible to lose data or damage equipment. Refer to Appendix B,
“Electrostatic Discharge,” for important information on using the proper
procedures.
This section includes:
■ Replacing the MSA1000 Controller
■ Replacing the MSA1000 Controller Cache
■ Replacing the Controller Cache Battery Pack
■ Replacing a Variable Speed Blower
■ Replacing a Power Supply
■ Replacing Hard Drives
■ Replacing the 2-Gb Small Form Factor Pluggable (SFP) Transceiver
Note: To take advantage of all features, check the MSA1000 website at
www.hp.com/go/msa1000
, to make sure you have the latest firmware.
230941-005_MSA1000_UG.book Page 61 Thursday, April 17, 2003 5:53 PM