User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Operation and Management
51Modular SAN Array 1000 User Guide
Applying Power
Before applying power to the MSA1000, all components of the storage system
must be installed and connected to the supported interconnect options. Hard drives
should be installed in the MSA1000 so that they can be identified and configured
at power up.
The MSA1000 components should be powered up in the following sequence:
1. Storage Expansion Enclosures
2. MSA1000
Power on the MSA1000 using the switch located in the far-right lower area of
the front panel of the MSA1000. After powering on, wait until the message
“
MSA1000 Startup Complete” appears on your display. This process may
take up to two minutes.
3. Interconnect Devices
4. Server(s)
230941-005_MSA1000_UG.book Page 51 Thursday, April 17, 2003 5:53 PM