User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
MSA1000 Setup and Sample Configurations
48 Modular SAN Array 1000 User Guide
Embedded MSA Hub 2/3 Configurations
Another basic configuration of the MSA1000 includes using the MSA Hub 2/3
option to connect two servers to the storage in a redundant, possibly clustered
environment.
Figure 17 is an illustration of this redundant configuration using the embedded
hub.
Figure 17: MSA Hub 2/3 connected to two servers, redundant configuration
654321
654321
MSA1000
Server 1
Server 2
4314 storage enclosure
4314 storage enclosure
230941-005_MSA1000_UG.book Page 48 Thursday, April 17, 2003 5:53 PM