User guide

Table Of Contents
MSA1000 Setup and Sample Configurations
35Modular SAN Array 1000 User Guide
Installing MSA1000 Option Kits
If any modifications to the MSA1000 standard shipping configuration need to be
made, it may be easier to make these changes before installing the MSA1000 in its
rack. Changes may include installing redundant controllers, additional controller
cache, embedded switches, or embedded hubs.
Detailed instructions for replacing and installing MSA1000 components are found
in other chapters of this guide or separate documents.
For instructions on installing a redundant controller, refer to the HP StorageWorks
Redundant Controller Option Kit Installation Instructions packaged with the
MSA1000 Controller.
For instructions on upgrading the MSA1000 Controller cache, see “Replacing the
MSA1000 Controller Cache” in the “Operation and Management” chapter of this
guide.
For instructions on installing an embedded MSA SAN Switch 2/8, refer to the HP
StorageWorks MSA SAN Switch 2/8 Installation Guide packaged with the switch.
For instructions on installing an embedded MSA Hub 2/3, refer to the HP
StorageWorks MSA 2/3 Hub Installation Instructions packaged with the hub.
Installing the MSA1000 in the Rack
Depending on the rack, the procedures for installing the MSA1000 will differ. The
MSA1000 is shipped with the necessary mounting rails. Refer to the
documentation that came with the rack for specific instructions.
230941-005_MSA1000_UG.book Page 35 Thursday, April 17, 2003 5:53 PM