User guide
Table Of Contents
- MSA1000 User Guide
- Contents
- About this Guide
- Chapter 1: Introduction
- Chapter 2: Operating System Specific Information
- Chapter 3: MSA1000 Setup and Sample Configurations
- Chapter 4: Operation and Management
- Chapter 5: Array Configuration Utility (ACU)
- Installing the ACU on the Server
- Accessing the ACU
- Description of Screen Regions
- Configuring a New Controller
- Modifying an Existing Controller
- Probability of Logical Drive Failure
- Chapter 6: Command Line Interface (CLI)
- CLI Overview
- CLI Setup
- Help Commands
- Display Commands
- Array Controller Configuration Commands
- LUN Management Commands
- Server Connection Commands
- Selective Storage Presentation/Access Control List Commands
- Appendix A: Regulatory Compliance Notices
- Appendix B: Electrostatic Discharge
- Appendix C: Specifications
- Appendix D: Hard Drive Arrays
- Appendix E: Recovering from Hard Drive Failure
- Appendix F: Controller Display Messages
- Appendix G: Recovery ROM and ROM Cloning
- Appendix H: SCSI ID Assignments
- Index
Operating System Specific Information
28 Modular SAN Array 1000 User Guide
Supported Software Components
■ Array Configuration Utility
■ Command Line Utility
■ Insight Manager 7
■ HP StorageWorks Secure Path for NetWare
■ Storage Event Broker for NetWare
■ SmartStart and Support Software version 5.50 or later
Supported Host Bus Adapters
■ FCA2210 Host Bus Adapter
Specific Configuration Needs
Initial system configuration tasks are detailed in the NetWare section of the
Modular SAN Array 1000 Quick Installation Guide. This guide is included in the
Modular SAN Array 1000 Setup and Management kit.
OpenVMS Environments
OpenVMS configurations that use the MSA1000 may range from a simple
single-controller MSA1000 connected to a single node to a complex fabric with
redundant-controller MSA1000s supporting multiple clusters with many nodes.
Supported Operating System Versions
For Fabric topology Fibre Channel SANs, the following OpenVMS operating
systems are currently supported:
■ OpenVMS Alpha Version 7.2-2 or later
For Loop topology Fibre Channel SANs, the following OpenVMS operating
system is currently supported:
■ OpenVMS Alpha Version 7.3-1 or later
230941-005_MSA1000_UG.book Page 28 Thursday, April 17, 2003 5:53 PM